Support 24/7
Text 215-766-5665

✕

Support 24/7
Text 215-766-5665

Support 24/7
Text 215-766-5665

✕

Support 24/7
Text 215-766-5665

How Arc Ratings Connect to NFPA 70E PPE Categories

Estimated reading: 2 minutes

NFPA 70E provides two methods for selecting arc-flash PPE: the Incident Energy Analysis and the PPE Category Method. When the PPE Category Method is used, arc-rated clothing and equipment are grouped into four categories, each with a minimum required arc rating.CAT 2 garments are commonly used for industrial daily wear when they align with the employer’s arc-flash risk assessment.

PPE Category Minimum Arc Rating Example Garment Ensemble
CAT 1 4 cal/cm² Arc-rated shirt and pants or arc-rated coverall
CAT 2 8 cal/cm² Arc-rated shirt and pants or arc-rated coverall
CAT 3 25 cal/cm² Arc-rated clothing system or arc flash suit with a minimum 25 cal/cm² system arc rating
CAT 4 40 cal/cm² Arc-rated clothing system or arc flash suit with a minimum 40 cal/cm² system arc rating

Note: This table is simplified and reflects typical garment applications. It does not list all required PPE.

IMPORTANT: The required protection applies to the full PPE ensemble

The selected clothing and other PPE must satisfy the requirements for the applicable category. When garments are layered to achieve a higher system arc rating, their individual ratings cannot simply be added together. The combined protection must be established through testing of the specific layered system.

Incident Energy Analysis Method

Under the Incident Energy Analysis Method, a qualified professional calculates the incident energy associated with the equipment and task, and the selected arc-rated clothing and PPE must have an arc rating that meets or exceeds that calculated value. The PPE Category Method and Incident Energy Analysis Method are both recognized under NFPA 70E, but they are alternative methods and should not be combined for the same piece of equipment.

ASTM F1506 governs the performance and labeling specification for arc-rated protective garments referenced under NFPA 70E. Compliant garments carry the arc rating, fiber content, care instructions, and ASTM F1506 standard designation on the label. For clothing within the scope of ASTM F1506, the absence of that compliance statement should be flagged and verified with the manufacturer or supplier.

Share this Article

How Arc Ratings Connect to NFPA 70E PPE Categories

Copy link

CONTENTS
✕

Calculate how much you can save with Tyndale’s AR/FR managed program solution.

 

✕